Jump to content


Photo

Installation rates - Perth

installation

  • Please log in to reply
4 replies to this topic

#1 JohnDB

JohnDB

    500 - 1500w RMS

  • Members
  • 506 posts
  • Gender:Male
  • Location:Perth
  • Interests:Family, Club motor sport, Golf, Car Audio, Travel, Photography
  • State:WA

Posted 08 April 2012 - 04:26 PM

Before I front up at a car install location here in Perth, I need to make sure I have my $’s in order. :good:

How many hours & $’s is the following likely to be?, labour costs only bearing in mind that I have purchased the equipment from MMATS Pro Audio in the USA and so they haven’t made any margin on selling me their own stock.

Any before anyone asks’s I didn’t but equipment from Woofersetc, I purchased direct from their head office in Florida, Dave Thompson.

1. Access standard head unit and attach LOC to reduce current for RCA input to amp (I would imagine this could be a 2-4hrs work) as the lower part of the dash and associated console would have to be removed, car is a Renault RS250 Megane.
2. Install 4 channel amp (probably in the trunk)- run active to front woofers and tweeters
3. Run power cable from battery to distribution block (inside cabin?) and install fuse
4. Run power cable to 4 channel amp
5. Run second power cable to boot mounted sub amp and RCA cable from LOC to sub amp
6. Optional – replace current door woofers and dash tweeters (again MMATS supplied)

I would believe this would be the better part of a full days labour, no knowing what install rates are I’m a bit lost as to what to expect? - $600, $700, $800, $900? More? :unknw:

I realise that every installation is unique and so you never know what problems you can encounter during an install, but a ball park figure would be appreciated by those in the know.

Thanks in anticipation of any feedback

#2 MAS Andrew

MAS Andrew

    500 - 1500w RMS

  • Members
  • 655 posts
  • Gender:Male
  • State:VIC

Posted 08 April 2012 - 06:47 PM

What area of Perth are you in?

#3 JohnDB

JohnDB

    500 - 1500w RMS

  • Members
  • 506 posts
  • Gender:Male
  • Location:Perth
  • Interests:Family, Club motor sport, Golf, Car Audio, Travel, Photography
  • State:WA

Posted 08 April 2012 - 09:27 PM

Vic Park, Weside and Alberts are just down the road on Albany highway so they would be likely spots for the install. any clues on a figure?

#4 MAS Andrew

MAS Andrew

    500 - 1500w RMS

  • Members
  • 655 posts
  • Gender:Male
  • State:VIC

Posted 08 April 2012 - 09:49 PM

Go and see Pete at Alberts.. He'll look after you.

#5 JohnDB

JohnDB

    500 - 1500w RMS

  • Members
  • 506 posts
  • Gender:Male
  • Location:Perth
  • Interests:Family, Club motor sport, Golf, Car Audio, Travel, Photography
  • State:WA

Posted 11 April 2012 - 10:48 PM

Off to USA on 22nd back first week May, will check them out then.





Also tagged with one or more of these keywords: installation